---

CREATE YOUR RECIPE

 

✦ The Timecup CM-700 coffee machine has four additional recipes that can be completely changed - delete and add steps, control the duration and power of heating, pause, maintain a certain temperature, change the name of the recipe, etc.

✦ All manipulations with additional recipes are made using the Timecup Commander application via the Bluetooth 4 wireless connection (Low Energy).

✦ Android or iOS required.

✦ Using the Timecup Commander application, you can create your own recipe for making coffee, milk, cocoa or any other drink that requires heating the liquid according to a predetermined program.

✦ Four recipes are already recorded in the memory of the coffee maker:

1. "Morning - making coffee for a longer recipe than traditional. Soft temperature increase mode
2. "Fast" - fast preparation of coffee. Almost an analogue of the Water/Coffee fast, but the temperature increase is divided into three stages.
3. "Greek" - preparation of coffee in Greek with long aging.
4. Cocoa - making cocoa without milk. Milk is added after the end of the recipe.

 

Description of user recipe commands (steps)

 

Heating

✦ Parameters:

1. Power (in %% of maximum) - varies from 10% to 100% in 10% increments
2. Temperature (in degrees C) - optional, varies from 40 to 100 in steps of 1, determines the target temperature of the step.
3. Time (in seconds) - optional, varies from 0 to 64000 sec., Determines the duration of the step.

✦ Temperature and time cannot be equal to zero at the same time.

✦ If the time is not equal to zero, then the step ends when the time runs out. If the temperature is not equal to zero, then if this temperature is reached during the step time, it will be maintained until the end of the step (time elapses).

✦ If time is zero, then the step ends when the target temperature is reached.

✦ If the target temperature is less than the current, then the step continues until the liquid cools to the target temperature, or until the time expires, if it is set.

---

Pause

✦ Parameters:

1. Time (in seconds) , varies from 0 to 64000 sec., Determines the duration of the step.

✦ The step ends after the set time has elapsed, while no other parameters are analyzed.

---

Signal

✦ Parameters:

1. The number of signals in the series.
2. Number of series.

---

Crema sensor enable

✦ Parameters:

1. Sensitivity (if = 0, then the value from the traditional recipe is used).
2. Step number to jump after sensor triggers.

✦ When the sensor is turned on, its value is stored (water / foam level at the moment of switching on). In the future, the sensor readings are continuously analyzed, and when they are exceeded by the sensitivity value, a jump to the indicated step number occurs.